Juniper Networks J6350 LEDs for Channelized T1/E1/ISDN PRI PIMs, Label Color State Description

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

■Maximum MTU value of 4500 bytes (for channelized T1 or E1 interface) and 4098 bytes (for ISDN PRI services)

NOTE: For a clear-channel T1 or E1 interface, the maximum MTU is 9150 bytes.

■56-Kbps and 64-Kbps modes

■ANSI T1.102, T1.107, and T1.403 standards compliance

■G.703, G.704, and G.706 E1 standards compliance

■Independent internal and external clocking system

■Loopback, bit error rate test (BERT), T1 facilities data link (FDL), and long buildout diagnostics

For pinouts of cable connectors for channelized T1/E1/ISDN PRI PIMs, see “ISDN

RJ-45 Connector Pinout” on page 239.

To install or remove a PIM, see “Replacing a PIM” on page 172.

Channelized T1/E1/ISDN PRI LEDs indicate PIM and port status. Table 27 on page 58 describes the meaning of the LED states.

NOTE: The STATUS LED displays channelized T1 or E1 port activity and alarms only. It does not display ISDN PRI B-channel or D-channel status.

Table 27: LEDs for Channelized T1/E1/ISDN PRI PIMs

Label	Color	State	Description
ONLINE	Green	On steadily	PIM is online and
			operational.
	Unlit	Off	PIM is not online.
STATUS	Green	On steadily	Port is online with no
			alarms or failures, and
			the physical layer is
			active.
	Red	Online	Port is active with a
			local alarm. The
			router has detected a
			failure and the
			physical layer is
			inactive.
	Yellow	Online	Port is online with
			alarms for remote
			failures.
	Unlit	Offline	Port is disabled.

58■ Field-Replaceable PIMs