J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Figure 98: Crypto Accelerator Module Location on J4350 and J6350 Routers

To modify a Crypto Accelerator Module configuration, use the following procedures:

Removing a J4350 or J6350 Crypto Accelerator Module on page 202

Installing a J4350 or j6350 Crypto Accelerator Module on page 204

Removing a J4350 or J6350 Crypto Accelerator Module

NOTE: If you are installing a Crypto Accelerator Module into a J4350 Services Router for the first time, proceed directly to “Installing a J4350 or j6350 Crypto Accelerator Module” on page 204.

To remove the Crypto Accelerator Module:

1.Place an electrostatic bag or antistatic mat on a flat stable surface to receive the Crypto Module.

2.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 251.

3.Press and release the power button to power off the Services Router. Wait for the POWER LED to turn off.

4.Unplug the power cord or cable from the power source receptacle.

5.Remove the screws from the sides and the top of the chassis, and slide the cover off the chassis.

202Replacing Crypto Accelerator Modules on J4350 and J6350 Routers

Page 224
Image 224
Juniper Networks manual Removing a J4350 or J6350 Crypto Accelerator Module