Using DSP5000C | 14 |
|
|
Basic operation of DSP5000C
Note DSP5000C is factory set for the most common installation, one using the full features of a Meridian
To switch from CD to another input, say Radio:
1. Press Radio
In Type 1, this will select RD on a Meridian 562/5.
The speaker displays
rd 65
Here rd means that the source is a radio tuner, and that the DSP5000C expects a Meridian 504 to be connected to the Radio input of the 562/5 and into the communications system. The 504 can now be controlled by the MSR, and its status can be displayed on the master DSP5000C. 65 is the volume number.
The other input keys on the MSR (e.g. LP, Tape 1, Video and Tape 2) operate in a similar way in Type 1:
The LP input of a Meridian 562 is engaged. The D1 input of the
DSP5000C is selected. The display shows
LP 65
The Tape 1 input of a Meridian 562 is engaged. The D1 input of the
DSP5000C is selected. The display shows
t1 65
Note These responses are for DSP5000Cs set up for Types 1 and 6, and can be changed. See later.
Selecting a source will bring DSP5000C out of Standby.
Note If you have stored a preferred tone setting for a source, you must recall it after switching to the source; recall settings by pressing Store.
Putting the DSP5000C in Standby1. Press Off on the remote control
Coming out of StandbyTo start up the DSP5000C from Standby:
1.Select a source, using the remote control or
1.If the DSP5000C is part of a Meridian system, bring any component out of Standby (for example, start up a Meridian CD player).
DSP5000C User Guide