Using DSP5000C

9

 

 

Installing your DSP5000C

General precautions

Before carrying out any installation, you should ensure that the

DSP5000C is marked with the correct voltage for your local AC supply.

Should this not be the case, do not proceed, but contact your dealer.

As a general rule, you should not make any connections to the DSP5000C, or to any other component in your system, when the AC power supply is switched on.

For full details of Type settings and configuring DSP5000C, see

Customising DSP5000C: an overview, on page 27
Customising features

The DSP5000C is very flexible. Its functions can be significantly customised, which means that you can set up your system so that it suits you exactly.

Customising DSP5000C: an overview, on page 27, describes your options in detail. By the time you have set up DSP5000C according to your needs, you will be aware of how the alternative choices available to you can differ from the standard configurations.

We recommend that you first get to know the DSP5000C by using one of the standard setups, and by working through this manual. Do not be afraid later to experiment with customising – we have given you a simple way of getting back to where you started from! (see page 30).

DSP5000C as provided has 8 standard configurations which we call Type settings. Each Type gives a different set of standard options; this feature is described fully on page 30.

Warning By selecting a Type, you automatically reset all custom settings for DSP5000C to the factory defaults – this includes all tone settings.

DSP5000C has 7 operating modes (not to be confused with setup Types):

∙Standby

∙Normal

∙Type

∙Config

∙Setup

∙Calibrate

∙Test

Standby and Normal are the everyday operating modes. The basic operating instructions refer to these.

Type is used to reset the DSP5000C to one of eight factory-preset conditions. The main uses of Type are to specify what type of preamplifier is being used, and to make an initial choice of centre/left/right and master/slave speakers.

Config could be considered as an editing setup mode. In Config you can choose any aspect of left/right/centre/sub, master/slave, sources or preamplifiers individually, without losing any other settings you may have made.

Setup is an operating mode in which the speaker plays and in which additional menu items are available. The idea behind Setup is that in this mode you can choose and store in memory the preferred tone settings for every source. Going to Normal operation then prevents them from being accidentally lost, and can simplify everyday operation.

Customisation is described more fully in Configuring DSP5000C: an overview, on page 27.

DSP5000C User Guide