Using DSP5000C | 20 |
|
|
in 565). This has been done specifically to allow you to tonally match the centre to the left and right main pair which may have a different sound.
Bass controlThe bass control allows you to adjust the bass response in the room. The responses of the bass control in DSP5000C are shown in Appendix 4 on page 58.
To adjust the bass:
1.Press the w or e menu key until the bass cursor display shows. The master display will momentarily show
b.0.0This allows you to ask the DSP5000C what its bass setting is without changing it.
To change the bass:
1.Make sure that you can see the bass cursor display on the master.
2.Press the n menu key. The display will change to
b. 0.5
and the bass will increase by 0.5dB. The bass can be adjusted by ±5 dB, incremented in 0.5 dB steps.
To restore the flat condition:
1. Press Clear
Note This also restores balance and tilt.
∙To store a bass setting, you must be in Setup mode; see pages 37 and 21
∙To recall a bass setting, use the Store key; see page 22
Bass explainedThe bass control allows you to adjust the
All DSP5000Cs in the installation take on the same bass setting as the master. This is essential for correct stereo.
PhaseYou can invert the absolute phase of the signal. To review the absolute phase:
1.Press the w or e menu key until the phase display shows. The master display will momentarily show
POS.or this:
nEG.This allows you to ask the DSP5000C what its phase setting is without changing it.
To change the absolute phase1. Press the n or s menu key
DSP5000C User Guide