Customising using Config

33

 

 

The display looks like this:

Cd ??

The first letters tell you which options are available to you, as follows:

∙500 tells you that this system operates in Meridian 500-Series mode. All controllable Meridian products must be 500 compatible. Also use this if the DSP5000C is the only controllable preamplifier connected (i.e. the source keys on the MSR will only select between the two inputs of the DSP5000C).

∙Pr. means that the preamplifier for this system will be a Meridian 201, 601, 603 or compatible, and that source keys on the MSR will automatically switch the inputs on the preamplifier regardless of other selections. Implies and engages 200 mode.

∙Cd means that the preamplifier for this system will be a Meridian CD/Pre (e.g. a 207 or 208). The first four input keys (CD, Radio, LP and Tape1) on the MSR will automatically switch the inputs on the CD/Pre regardless of other selections. Input keys Tape2 and Video will select CD on the CD/Pre. Implies 200 mode.

To move through these options:

1. Press n or s (menu keys)

Configuring options

This section allows you to make choices about whether the speaker will be system controller. This choice is only relevant to the master.

After a Type the display shows:

Auto

Choose from:

∙Auto This preferred option allows the system to ‘Auto Configure’.

∙N.Con Sets the speaker to be ‘Not Controller’ if it is a Master.

∙Con Sets the speaker to be ‘Controller’ if it is a Master.

We recommend trying to set the system using Auto. There may be specific instances when it is necessary to make the speaker ‘Not Controller’. (For example if the DSP5000C is invisible to the handset – e.g. behind a projection screen).

System address

1.Press the menu e key The display typically shows:

S.A. 1

This means the system address is 1. The 500 Comms allows for up to eight systems connected to the same bus for Multiroom installations. Unless specifically instructed otherwise by Meridian personnel; or your dealer, leave this set to 1.

Product address

1.Press the menu e key The display typically shows:

P.A. 1

This means the system address is 1. The 500 Comms allows for up to eight systems connected to the same bus for Multiroom installations. Unless specifically instructed otherwise by Meridian personnel; or your dealer, leave this set to 1.

DSP5000C User Guide