Operation 25

C.6

Press Play to action a programmed sequence.

Use with 504, 204 or 604 FM tuner

When a 204 or 604 is the system tuner, it can be controlled by the MSR but only if the DSP5000Cs are set up in 200 mode (for example by selecting Type 2. A 504 tuner can operate in both 200 and 500 modes.

Select the tuner with Radio. The display will show

rd. ##

where ## is the volume number. (If you are using another tuner which the DSP5000C cannot control, see the setup section on page 36, select Comms to ‘N.C.’)

To select a preset station, e.g. preset 4

1. Press 4

The DSP5000C will show a 'select cursor' display. For 500 mode the display is:

P.4

For 200 mode the display is:

S.4

2.Either press Play or wait for a short time. The tuner will go to preset number 4.

To select a higher preset, e.g. 23

1. Press 2 followed by 3

The DSP5000C will display

P.23

and then the tuner will go to preset 23.

The master DSP5000C can display either the preset number of the tuned station or its frequency. For example, if we tune to 92.3MHz and store this frequency as preset number 3, we can then press Display repeatedly and watch the master rotate its display between the following:

rd ##P.3

92.3

Note The DSP5000C cannot show the time displays of the 204.

6. Use the system, or put it into Standby.

DSP5000C User Guide