Customising using Config | 32 |
|
|
∙source menus
Inside Config you can move between them at will. To go to
1.root: press Clear
2.system: press Off
3.source: press a source key – e.g. CD
Note In Config, the speaker is silenced.
How to use Config1.Switch off the master DSP5000C, using the power switch on the back, and wait for 3 seconds
2.While pressing the 0 key on the remote control, switch the power on again. The display will indicate the root menu that shows the left/right/centre and master/slave settings; for example,
C.
indicates a centre master.
3. Release the 0 key
Root menu optionsThe root menu controls the overall operation of the DSP5000Cs, with options for master/slave and left/right/centre/subwoofer.
You get to the root menu by
1.Selecting Config, as above
or, at any stage in the Config programming process,
1. Pressing Clear or Off
Choosing left, right or centreTo change a left speaker into a right or centre, (or vice versa):
1. Press n or s on the remote control
Note Only if you have started with Type 6 or selected ‘CEn.Y’ elsewhere in Config, will you get the choices ‘C’ and ‘S’ for Centre and Subwoofer. If you want the speaker to be a Centre in a
Choosing master or slave
To change a master to a slave, or back again:
1.Press Play on the remote control
r. S.
This display indicates a right slave.
System menuTo get into the system menu:
1. Press the menu e key
Preamplifier optionsThe first digit in the system menu identifies the dominant preamplifier in the system.
1This choice also permits you to make the DSP5000C the system subwoofer. This choice would normally be made only for diagnosis!
DSP5000C User Guide