Customising DSP5000C: how to

28

 

 

How to customise DSP5000C

DSP5000C needs no customising to become operational. Once you have your system established, you may wish to review the customising options by reading Customising DSP5000C: an overview (page 27).

Customising: general procedure

DSP5000C has seven operating modes (not to be confused with Types):

∙Standby

∙Normal

∙Type

∙Config

∙Setup

∙Calibrate

∙Test

Standby and Normal are the everyday operating modes. The basic operating instructions refer to these.

When customising, you may need to use Type, Config and Setup, in that order, before reverting to Normal. In other cases, you may only need to use Config or Setup. Neither of these modes resets the DSP5000C, so you will not necessarily lose any settings you have previously made.

How to change back to Normal

To revert to Normal

1.Switch off the DSP5000C, using the power switch on the back

2.After a second, switch the DSP5000C's power on again

Note If you are in Calibrate or Test mode, refer to page 57 or 56.

The Type settings are described in detail in Appendix 1, on page 52

To use Config, see page 31

Type: an overview

Type restores one of the default settings. Other than selecting master/slave and left/right/centre/surround; no further actions are possible. Type always resets all stored settings, with the exception of calibration information. The DSP5000C does not play music in Type.

For example, Type 1 setup gives:

∙500 Series system only

∙All sources select the D1 input

∙DSP5000C expects a Meridian 500-Series CD and/or a controller such as 562

For example, Type 2 setup gives:

∙200/600 Series system only

∙CD selects the D1 input

∙all other sources select the D2 input

∙DSP5000C expects a Meridian CD preamp controller such as 208

For example, Type 6 setup gives:

∙500 Series system only

∙All sources select the D1 input

∙DSP5000C expects centre-channel in the system and the balance control is disabled.

Config: an overview

Config could be considered as an editing setup mode. In Config you can make individual choices about any aspect of left/right/centre/sub,

DSP5000C User Guide