Help 49

201MkIII. To find out which version you have, follow the instructions in the manual supplied with the 201. Version numbers count 1–9, then A– Y. If the software in your 201 is earlier than 201.7, your dealer will be able to obtain an up-to-date EPROM and fit it. Operating code can always be updated.

3.Make sure that the whole system is set up in either 200 mode or in 500 mode.

Note All Meridian products must be in the same mode. 200 or 600-Series products can only work in 200 mode and if you intend to incorporate these in a DSP5000C system, the speakers and any 500-Series components must be put into 200-mode (normally Type 2).

DSP5000C does not respond

The communications between MSR and speaker could be being interrupted by sunlight in the infra-red pickup behind the display.

DSP5000C goes silent when used hard

DSP5000C has a temperature-sensing system on board that prevents overheating of the electronics by cutting out the sound. The sound will reset when they have cooled down.

When this system is activated, the display on the speaker will show

Hot

What have you been playing?

Communications not working between DSP5000C and other Meridian products

If you have this problem, check the connections carefully. The section starting on page 43 deals with this in some detail. Then check the following:

∙Are you using a B-lead or P-lead instead of a B1-lead?

∙Are you using a Q-lead instead of a Q1-lead?

∙Are you using an A-lead with a Meridian tuner? The A-Lead is not suitable for this; you should request a B1-Lead.

If you cannot see an obvious problem, connect the Comms one product at a time. If you cannot solve the difficulty refer to your dealer, but first note the software versions fitted in all of your Meridian items.

To find out the software version for a Meridian product:

1.Press its Display key while it is in Standby. (If it does not have a display key, use a 209 remote control or refer to the manual supplied with the product).

Note your connections carefully.

Note Make sure that the whole system is set up in either 200 mode or in 500 mode.

Note All Meridian products must be in the same mode. 200 or 600-Series products can only work in 200 mode and if you intend to incorporate these in a DSP5000C system, the speakers and any 500-Series components must be put into 200-mode (normally Type 2).

DSP5000C User Guide