Using DSP5000C | 16 |
|
|
1
Here 1 is the number of the track currently playing on the disc.
If the disc includes significant index points, the display will be like this:
3.4
3.4here means track 3, index point 4. In theory, with the right disc, we could see displays of track and index up to 99.99. Index point 1 is never displayed.
While the CD player is loading a disc (reading the disc’s directory), the
DSP5000C will show the directory message:
dirAt the end of a CD, the DSP5000C will detect the
1.With the disc playing, press Display again. You will see a disc time display, counting up as the disc plays.
2.Press Display again. You now have a display of time for the current track only, also counting up as the disc plays.
3.Press Display again. The display should go blank on both master and slave.
4.Pressing Display again brings you back to the source and volume display.
One useful way to set up DSP5000C is to leave the track display on the master, since the 565 or any slave always displays the source and volume. If the CD player is in the same room, you can adjust its display to give you additional time information.
Try pressing Display until you are familiar with its operation.
Other information reviewed in Standby1.Press and hold Display
The display will show the version number of the microcontroller software, followed by the
2.2
P1.81d1.2441bNote The last DSP version number will depend on the operating mode of the DSP5000C. The first two digits represent the sampling frequency; DSP5000C automatically reloads a new program for each sampling rate. The version numbers will also be different in Test and Calibrate.
VolumeTo raise or lower the volume:
1. Press the upper or lower red key
The volume level displayed should count up or down, and will range from 1 to 99. Each step is precisely 1dB.
Note Subjectively one judges a volume increase of 9dB to be equivalent to a doubling of loudness, so each volume number represents about a 11% change in loudness, with nine steps to double loudness.
DSP5000C User Guide