MicroNet Technology user manual Operating Procedure - LCD Display, Initialize SP5100 IP Phone

2Operating Procedure – LCD Display

2.1Initialize SP5100 IP Phone

1.When power on the SP5100 IP Phone, the LCD screen shows as below. IP-Phone

Board Start Booting

2.Wait around one minute until the SP5100 IP Phone finishes boot program initialization.

3.User can see flashing greeting as below:

System Initializing………

4.Then IP Phone get into standby mode: IP-Phone

GK 10:10:10 AM

The main LCD screen would be shown as similar as above. The GK word means the SP5100 IP Phone is in Gatekeeper Mode, and when IP Phone is connected to SNTP server, on LCD will show current time from SNTP server.

5.After pressing the PSTN button, the GK word will be replaced by PSTN. Then IP Phone is in PSTN Mode. Please notice that in PSTN mode user must plug PSTN line in RJ-11 port.

	IP-Phone
PSTN	10:10:10 AM

Press Í or Î to enter configuration mode then press OK Bottom to enter certain menu. There are 6 selections for configuration.

1.System Configuration (mandatory, protected by password)

2.User Line Number (mandatory)

3.Ring Configuration

4.Indicate Forward Type

5.Message Box

6.Phone Address Book

9