MicroNet Technology SP5100 user manual sysconf command

contact with server, IP Phone will keep trying to connect. After re-connected, IP Phone will also restart system. On the other hand, if users disable this function, IP Phone won’t reboot and keep trying to connect. (pppoe –reboot 0 / 1)

Note: Firmware of IP Phone is separated into normal version and PPPoE version.

In Normal version has no ToS command.

5.12 [sysconf] command

This command displays the system information and configuration.

•-print: display system overall information and configuration.

•-plan: It is for setting dial numbering plan. While e164 number is three digits, the plan should be set as 3 or 0. The plan 0 is for any positive digits use.

Note: Before change to Peer-to-Peer mode from GK mode, please remember to set dial plan as 0, or it may works not normally in P2P mode.

•-keypad: set DTMF type .User can select DTMF type IP Phone receive and transmit.(sysconf –keypad 0 / 1 / 2 / 3 , 0 for inband ,1 for H.245 alphanumeric, 2 for H.245 signal type, 3 for Q.931 user info, 4 for RFC2833.)

•-idto: set the duration (in second) of two pressed digits in dial mode as timed out. If after the duration user hasn’t pressed next number, IP Phone will dial out all number pressed.

•-eod: select end of dialing key, e.g set end of dial key as OK button , after finished pressing dialing number then press OK will dial out. (sysconf –eod 0/1/2/3 , 0 for no end of dial key , 1 for “OK” button , 2 for “#” button , 3 for “＊” button )

•-h450: Enable or disable H.450 related features, which include transfer, hold and forward.

46