Miele 09 645 470 manual Plumbing, A stopcock with a 3/4 male thread must be provided on site

Plumbing

–The inlet hose is approx. 1.5 m long. A 1.5 m long flexible metal extension hose, pressure tested to 14000 kPa/140 bar) is available as an op‐ tional accessory, if required.

–A stopcock with a 3/4" male thread must be provided on site.

–This appliance is constructed to comply with IEC/EN/DIN 61770 // VDE 0700 Section 600, and may be connected to a suitable supply with‐ out an extra non-return valve if na‐ tional regulations permit.

–The water pressure (flow pressure at the take-off point) must be between 30 and 1000 kPa (0.3 und 10 bar). If the water pressure is lower than this, the fault message Water intake will appear in the display (see "Problem solving guide"). If the water pressure is too high, a pressure reducer valve must be fitted.

After connecting the dishwasher to the water supply, check that all plumbing connections are watertight.

To avoid any damage to the ap‐ pliance, the dishwasher must only be connected to a fully vented plumbing system.

The inlet hose must not be shortened or damaged in any way as it contains electrical components (see illustration).

80