Operation
Before each use
^When using a perforated cooking container, push the condensate tray onto the lowest shelf runner to catch any drips.
^Fill the water container.
You do not need to remove the insert.
Only use mains tap water. Never use distilled or mineral water.
The water level must be between the two markings (min. 0.75 l and max.
1.2l). These are located inside and outside the container. On no account exceed the upper or maximum level marker. The amount of water required will vary depending on what you are cooking.
Using hot water from a kettle will shorten the
^Use both hands to carry the water container. Take care not to let any water spill out. Push the water container into the appliance until it connects.
If the water container is not positioned correctly, the appliance will not heat up and after a while F20 will appear in the display (see "Problem solving guide").
Programming steps in brief
To make a selection you turn the selector, and to confirm your selection you press it.
The function selector is used to:
ASwitch the appliance on by pressing it
BSelect and confirm a cooking function
The time/temperature selector is used to:
CConfirm the recommended temperature or to change it and then confirm the change
DSelect and confirm a cooking duration
The programme then starts automatically.
If you do not complete the programming within 15 minutes, the appliance will switch itself off.
The cooking functions and programming steps are described in more detail on the following pages.
19
