Frequently asked questions
What if "F" and a number appear in the oven display?
"F15": The Self Clean | Turn the program selector to "0" and then to "Light". |
program was interrupted | After 60 seconds the error message will go out, |
during the heating phase. | "PYRO" and the symbol "p" will light up in the display. |
| After another 30 seconds the symbol "p" will flash. |
| Turn the program selector to "0". The oven is ready to |
| use. |
| If you still cannot operate the oven or if this error |
| message occurs again call Technical Service. |
|
|
"F17": A temperature | The oven can still be used but, the catalytic |
sensor is defective. | converter will not work properly and the Self Clean |
| program cannot be selected. |
| If the temperature sensor fails during the cleaning |
| program the oven door cannot be opened until the |
| internal oven temperature has dropped to below |
| 530°F (280°C) and the "p" symbol flashes in the |
| display. |
|
|
What if the timer display is dark when the oven is first turned on?
This is normal. If the time display has been turned off, the display will remain dark. If the "Start" and "End" buttons are pressed simultaneously, "12:00" should appear in the display.
What if the time of day cannot be entered after a power failure?
Check whether the program selector is set to "0". The time of day can only be entered when the program selector is set to "0".
54