Miller Electric Bobcat 250 manual Connecting to Weld Output Terminals, Stop engine

5-6. Connecting to Weld Output Terminals

12

6

3

Do not place anything between weld cable terminal and copper bar.

4

5

.A complete Parts List is available at www.MillerWelds.com

! Stop engine.

1Work Weld Output Terminal

2Electrode Weld Output Terminal Connect work cable to Work terminal.

Connect electrode holder cable or electrode weld cable to Electrode ter- minal for Stick and MIG welding.

Connect torch cable to Electrode ter- minal for TIG welding.

Use Process Selector switch to select type of weld output (see Section 6-1).

.See Sections 6-3thru 6-5for typi-

cal process connections and control settings.

! Failure to properly connect weld cables may cause exces- sive heat and start a fire, or damage your machine.

3Weld Output Terminal

4Supplied Weld Output Terminal Nut

5Weld Cable Terminal

6Copper Bar

Remove supplied nut from weld out- put terminal. Slide weld cable terminal onto weld output terminal and secure with nut so that weld cable terminal is tight against copper bar. Do not

place anything between weld cable terminal and copper bar. Make sure that the surfaces of the weld cable terminal and copper bar are clean.

Tools Needed:

3/4 in

Correct Installation Incorrect Installation

803 750-B / Ref. 228 201-B / 803 778-A

OM-4419 Page 21