Miller Electric OM-1589 manual Side and Rear Panel Controls, Gun Controls

4-4. Side and Rear Panel Controls

1 2 3

4

5

6

7

10 9 8

11

1Mode Display

2Data Card Slot

3Parameter Display

4Parameter Increase Button

5Parameter Decrease Button

6Parameter Select Button Press button to move > in display.

7Optional Gas Flow Adjustment Knob

Allows accurately presetting gas flow rate on wire feeder front panel digital display.

8 Circuit Breaker CB1

CB1 protects the wire feeder from overload. If CB1 trips, the wire feed- er shuts down. Allow a cooling peri- od and manually reset the breaker.

9 Mode Select Button

Press button to move > in display.

10Torque Switch (See Section 3-11)

11Power Switch

Use Power switch to turn wire feeder On and Off.

Ref. 800 690-A / Ref. 800 869

4-5. Gun Controls

1 Trigger

Press trigger to energize welding power source contactor (if applica- ble), start shielding gas flow, and begin wire feed.

For shielding gas preflow and post- flow, partially press trigger before and partially release after welding.

2 Increase/Decrease Switch

Use switch to adjust value of se- lected parameter. The numbers around the control are for reference only.

1

2

Ref. 800 939

OM-1589 Page 22