10-2. Redefining Teach Points
Redefining IPM Teach Point
Redefining IPM is not normally required unless special wire or unusual joint design is needed.
1
5 | 0 | T | r i m |
> 4 | 5 | 0 | I P M |
|
|
| And |
|
| Purge | |
P r g 1 P u l s e
1 IPM
IPM determines the weld metal de- position rate.
.Redefining IPM is not normally required unless special wire or unusual joint design is needed.
Use front panel parameter select button to move > to select IPM. Use Display Control to select teach point value.
Press and hold Purge button while turning Display Control to redefine the ipm teach point. For example: there are teach points at 215, 270, and 325 ipm; the teach point at 270 can be adjusted to a wire feed speed of 216 to 324 ipm.
5 | 0 | T r | i m | P r g 1 |
> 4 6 0 | I | P M | P u l s e | |
Redefining Pulse Parameters
2Apk − Peak Amperage
3Abk − Background Amperage
Peak and background amperage depend on the range of the welding power source.
4PPS − Pulses Per Second Of
5PWms − Pulse Width Of
Use side panel controls to change pulse parameters. See Menu Guide for detailed programming steps.
After values are set, strike and maintain an arc for five seconds. Do this for each teach point.
End weld by releasing gun trigger, not by pulling gun out of weld. Re- peat for each custom teach point.
2The taught arc length represents a Trim (arc length) setting of 50.
Once the teach points are set, the wire feeder adjusts parameters be- tween teach points synergically.
P r o c e s s
3
T e a c h | O n | |
2 | 1 5 | I P M |
>2 | 1 0 | A p k |
4 | 0 | A b k |
4
5
2 1 5 | I P M | 2 1 0 | A p k | |
2 1 0 | A p k | 4 0 | A b k | |
>4 | 0 | A b k | >6 5 | P P S |
6 | 5 | P P S | 1 . 1 | PWm s |
2 1 | 0 | A p k |
4 0 |
| A b k |
6 5 |
| P P S |
>1 . 1 | PWm s | |
Ref.
