.A complete Parts List is available at www.MillerWelds.com
5-4. Timers
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 4 | |||||
3 | |||||||||||
1 | 2 |
1Voltage Control
2Wire Speed Control
3Voltmeter
4Wire Feed Speed Meter
To enter the TIMERS menu press and hold the gun trigger while turning on the power switch until the left meter displays (run), then release trigger.
Once in the TIMERS menu, rotate the left knob clockwise (CW) to find the particular item, and rotate the right knob to change the setting.
The following items can be adjusted by ro- tating the left knob clockwise (CW):
Preflow (PrE) − The amount of time that the shielding gas will flow after the trigger is depressed and before the welding arc will be allowed to be active. The range is from 0.0 to 5.0 seconds.
Postflow (POS) − The amount of time that the shielding gas will flow after the arc has been shut off. The range is from 0.0 to 10.0 seconds.
Burnback (Bur) − The amount of time that the welding wire remains electrically ener-
gized after the wire feeding has stopped. The range is from 0.01 to 0.25 seconds.
Spot Timer (SPO) − The amount of time that the arc will be active before it shuts off automatically. The range is from 0 to 120 seconds. Spot timer is reset upon release of welding gun trigger.
“Stitch” Timer (dLY) − Used in conjunc- tion with the Spot timer and while the trigger is continuously depressed. Controls the amount of time that the arc will be inactive after the Spot timer times out. The range is from 0 to 120 seconds.
To save settings and exit the TIMERS menu, depress the gun trigger.
