Heavy Duty Portable Band Saw Table 48-08-0260
For additional safety instructions, read Safety Instruction Book No.
Symbology
CE Conformity Mark
SEMKO Safety Mark
WARNING! To reduce the risk of personal injury, user must read and understand Operator’s Manual
A 48-08-0260
1- Handle
2- Band Saw
3- Mounting Vise
4- Chain Hook
5- Swivel Pin
6- Crank Nut
7- Chain
8- Work Surface
9- Band Saw Table
10- Mounting Bracket Screw
11- Swivel Bracket Clamp Nut
12- Locking Pin
13a - Swivel Bracket (Deep Cut)
13b - Swivel Bracket (Regular Cut)
14 - Mounting Bracket
15- Front Handle Retaining Screw
B Assembly
16 - Socket Head Cap Screws
17 - Hardened Washers
18 - Hex Wrench
19- Front Handle
20- Band Saw Blade
21- Clearance Slot
Mounting on Workbench
The MILWAUKEE Band Saw Table must be mounted to a wooden or metal workbench with four bolts. Be sure to choose a loca- tion with sufficient room on each side to accommodate the cutting of long stock.
Mounting on Portable Legs
WARNING!
To reduce the risk of personal injury caused by tipping, use legs of equal lengths that will provide a comfortable working height. Keep table level, place stand securely on level surface. Sup- port overhanging stock.
The MILWAUKEE Band Saw Table is equipped with four pipe connectors, located on the underside of the table, to accommo- date 3/4" threaded pipe for use as legs. This converts the table into a stand. The legs are not provided with the table. The length of the legs should be less than 31" (790 mm).
Mounting the Saw to the Table
WARNING!
To reduce the risk of injury, always un- plug tool before mounting to or remov- ing from table. Do not transport the saw when attached to the table.
With the table properly mounted on a bench or legs, place the swivel bracket in the po- sition shown in (Fig. 1), where it is secured in place with a locking pin. Line up the mount- ing bracket with the left pair of holes in the swivel bracket (for Deep Cut Band Saws). Install the two socket head cap screws and hardened washers provided. Hand tighten the screws until final adjustments are made.
Use the hex wrench provided to remove the front handle retaining screw and handle (Fig. 2). Store the handle for future use. The screw is to be used for mounting the saw in the next step.
Pull out the locking pin and swing the mount- ing bracket forward (Fig. 3). With the tool equipped with a blade, place the tool on the table with the blade resting in the clearance slot in the work surface. Support it by the handle. Line up the front handle and mount- ing slot with the key in the mounting bracket. Install the front handle screw and tighten firmly.
English | 6 |
