Clamping the Stock
WARNING!
Always support overhanging stock on both sides of the blade to prevent tip- ping of the table and to control the cut- off piece.
With the tool locked in the upright position, place the stock on the work surface and against the vertical vice supports.
Support overhanging stock on both sides of the blade to prevent tipping of the table and to control the
Wrap the chain around the workpiece and drop the excess chain between the chain hook and the back of the vice. Lift the hook and place it over the highest chain pin it can easily reach. Tighten the crank nut to se- curely clamp the workpiece in place (Fig. 9).
Typical Application
WARNING!
Always wear safety goggles or safety glasses with side shields when cut- ting.
NOTE: After the table is completely assem- bled and adjusted, a trial cut should be made to be sure the blade is square with the stock. If the cut is not square, or the blade binds, unplug the tool and make minor adjustments as necessary.
1.With the Band Saw locked in the upright position, clamp the workpiece in a sta- ble position that will permit the greatest number of teeth to be in contact with the workpiece at one time.
2.Select the proper blade for the job. Re- fer to the Band Saw operator’s manual or MILWAUKEE’s catalog for complete selection of blades.
3.Release the locking pin.
4.Keep hands away from the table.
5.Depress switch and allow the tool to reach the selected speed before low- ering onto the workpiece. Allow the weight of the saw to do the work.
6.If the blade makes a clicking sound as it passes through the workpiece, it may be defective. Stop the tool. Unplug the tool, inspect and replace the blade if necessary.
7.When the cut is complete, release switch and allow the blade to come to a complete stop before removing the workpiece or
8.Raise the tool to the locked position, release clamp and remove workpiece and
Removing Band Saw from Table
1.Unplug tool.
2.Unclamp and remove workpiece.
3.With the tool in the upright position, re- lease locking pin and lower tool to the machined work surface.
4.Use the hex wrench to remove the screw that secures the tool to the mounting bracket and remove the tool.
5.Replace the front handle and handle screw on the tool, and tighten firmly with the hex wrench.
Maintenance
Repairs
Use only identical MILWAUKEE replace- ments parts. Always take the tool to an au- thorized MILWAUKEE service center for re- pairs and maintenance.
Refer to MILWAUKEE’S catalog for com- plete selection of tools and accessories.
English | 8 |
