Mitel NuPoint Messenger Technical Documentation - Release 7.0
Figure 4-5 Sample Report of Pager Systems Access Codes
Enter one of the following index numbers:
Index Dial String Paging System Name
0... T9T Outside line
1... T9T1415 415 Area Code
2... T9T1408 408 Area Code
3... T9T1916325 PAGER 916-325
4... T Internal Pager calls
5... Empty
6... [ No Name ]
7... [ No Name ]
8... [ No Name ]
9... [ No Name ]
10... [ No Name ]
11... [ No Name ]
12... [ No Name ]
13... [ No Name ]
14... [ No Name ]
15... [ No Name ]
Note that, in this sample, pager systems 6 through 15 have no name. These are pager systems
that are not yet set up. Pager system 5 (Empty) is set up for use with pagers whose entire dial
strings are contained in the pager number.
If you need to add a pager that requires the outdialing of more than 16 characters (thus the
coding string is too long to fit into the pager number field) and no appropriate outdial index
already exists, you must configure a new pager system before you can add the pager.
Pager Number
The pager number tells the server what numbers and/or characters to dial after the pager system
dial string, and before the post-pager number. See “Pager System Dial Strings” in the previous
section.
Pager numbers are limited to 16 characters.
A mailbox FCOS with feature bit 124 (User can change paging phone number) or 143 (User can
change message delivery number) allows the user to change the pager number without affecting
the post-pager number. Refer to the Features Class of Service chapter for more information
about FCOSs and feature bits.
Post-Pager Number
The post-pager number is used in two cases. With display pagers, the post-pager number
(typically the NuPoint Voice telephone number or the mailbox owner’s mailbox number) is
displayed on the pager screen. A second use is when the mailbox owner can change the pager
number, and non-numeric pager dial string characters must be transmitted after the pager
number to ensure a successful page. If the mailbox owner changes the pager number, then these
non-numeric characters cannot be entered on the telephone set. In this case the post-pager
number tells the server what numbers and/or characters to dial after the paging or message
delivery number a user enters from the keypad. Such characters include G, +, and T. Mailbox
owners cannot alter this post-pager number from the keypad.
Post-pager numbers are limited to 24 digits.
©Copyright 2002, Mitel Networks Corporation 47