4Press Select or to return to the stand-by display.

appears.

The alarm sounds for up to

1minute. Alarm clock and a vibrat- ing bell symbol appear with the cur- rent time and the softkeys,

Valid. and No ring . During a call, the alarm also sounds.

To stop the alarm: Press Valid. .

To use as a Reminder or Snooze Alarm:

Press No ring , or any other key (except Valid. ) to stop the alarm. The alarm icon remain on the display and the alarm rings again 3 minutes later.

You can repeat the snooze for up to 15 minutes, after which the phone returns to its previous state, either off or on stand-by.

To turn off the alarm:

1Press . Select Office Tools.

2Select Alarm clock.

3Select Off. Confirmation appears.

4Press and hold Exit or to return to the stand-by dis- play.

Caution - Please remember to turn off the alarm feature when boarding an aircraft where the use of a mobile phone is not permitted and is illegal. Alterna- tively, you can remove the bat- tery after turning off the phone. See the General safety warnings on page 4.

Auto-switch

You can set your phone to switch on and off automatically. Turning it off helps to conserve battery life. Please note that during auto-switch

on, you must re-enter your PIN code. The phone does not go into power saving mode until you enter your code. To activate the auto- switch:

1Press . Select Office Tools.

2Select Auto-switch.

3Select Auto-switch-on.

4Select On.

5Enter the time you want the phone to turn on and

press OK . Confirmation appears.

6Select Auto-switch-off.

7Select On.

8Enter the time you want the phone to turn off and press OK .

9Press and hold Exit or to return to the stand-by dis-

play. The icon appears in the stand-by display.

To turn off the auto-switch:

1Press . Select Office Tools.

2Select Auto-switch.

3Select Auto-switch-on.

4Select Off. Stored appears.

5Select Auto-switch-off.

6Select Off. Stored appears.

7Press and hold Exit or to return to the stand-by dis- play.

Calculator

To access and use the calculator:

1Press . Select Office Tools.

2Select Calculator.

3Enter a number and press several times to choose +, -,

*or / or to enter a ,.

4Enter the second number and

either repeat step 3 or select = to compute. Select Clear to correct any mis- takes or clear the display.

5Press to return to the stand-by display.

The menu

45

Page 45
Image 45
Mitsubishi Electronics 110 manual Auto-switch, Select Off. Stored appears, Calculator