Remote control
Battery installation
Use two (AA, R6) size batteries.
Inserting the batteries into the remote control
1.Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.
2.Load the batteries making sure that they are positioned correctly (+ to +, and - to
• Load the batteries from - spring side, and make sure to set them tightly.
3.Replace the back cover.
Removing the batteries from the remote control
Remove the back cover of the remote control and take out the batteries.
Caution:
•Use of a battery of wrong type may cause explosion.
•Only
•Dispose of used batteries according to your local regulations.
•Before you dispose of the batteries, insulate them by placing insulation tape on the positive (+) and negative
•Batteries may explode if misused. Do not recharge, disassemble, or heat the batteries, or put them into fire or water.
•Be sure to handle the batteries according to the instructions.
•Load the batteries with its positive (+) and negative
•Keep batteries out of reach of children and pets. If children swallow the battery, see a doctor immediately.
•Remove the batteries, if the remote control is not used for a long time.
•Do not combine a new battery with an old one.
•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.
•Do not carry or store the batteries together with metallic ballpoint pens, necklaces, coins, or hairpins. Otherwise, they may short out, causing explosion or liquid leakage and resulting in fire or injury.
•Do not store the batteries where they are exposed to direct sunlight or subjected to high temperature and high humidity.
High temperature and high humidity may cause corrosion or liquid leakage.
Operation range (of the remote control)
The maximum operation distance of the remote control is about 10 m (or about 32 feet) when the remote control is pointed at the remote control sensor of the projector. When the remote control is pointed to the screen, the distance from the remote control to the projector via the screen should be 5 m or less. However, the operation distance varies depending on the type of the screen used.
Reception angle (horizontal)
30° 
30°
Reception angle (vertical) |
|
20° | 20° |
| |
10° | 10° |
| |
Reception angle (vertical), ceiling mount |
|
20° | 20° |
|
Important:
•Do not expose the remote control sensor to direct sunlight or fluorescent. Keep a distance at least 2 m (6.5 feet) between the remote control sensor and the fluorescent light to ensure correct operation of the remote control. Inverted fluorescent light, if located near the projector, may interfere the remote control.
•When you use the remote control too close to the remote control sensor, the remote control may not work correctly.
