Mitsubishi Electronics MIM-G01 manual +ICF - Data Format, +IFC - Flow Control, DCEbyDTE, DTEbyDCE

Appendix AT Commands MIM-G01

+ICF – Data Format

This Command sets data format of serial interface.

Command	Possible answers
AT+ICF?	+ICF: <format>,<parity>
	OK
	Note: current values
AT+ICF=<format>,<parity>	OK

Tab. 8-6:+ICF – Data Format
Defined parameters:
<format>		<parity>	<format>		<parity>
1: 8 Data 2	Stop	0: Odd	4: 7 Data 2	Stop	3: Space
2: 8 Data 1	Parity 1 Stop	1: Even	5: 7 Data 1	Parity 1 Stop 4: None
3: 8 Data 1	Stop	2: Mark	6: 7 Data 1	Stop

If <format> is 1, 3, 4 or 6, <parity> will be ignored

+IFC – Flow Control

This Command determines flow control on serial interface.

Command		Possible answers
AT+IFC?		+IFF: <DCE_by_DTE>,<DTE_by_DCE>
		OK
		Note: current values
AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>		OK
Tab. 8-7:+IFC – Flow Control
Defined parameters:
< DCE_by_DTE >	< DTE_by_DCE >
0: none	0: none
2: RTS	2: CTS

Mitsubishi Industrial Modem 8 - 3