Mitsubishi Electronics MIM-A01 manual Operation, MIM-G01, Mitsubishi Electric

MIM-G01 Operation

5 Operation

If you have followed the steps in the chapters 3 and 4, your modem is ready for operation.

5.1MIM-G01

The MIM-G01 presents two LEDs, which indicate the devices current operating mode. After the power supply has been switched on, a self test will be executed. The end of this test is indicated by a acoustic signal (short beep). After the test, the device tries to make a connection to the GSM network. The green LED will flash slowly when the log in was successful..

5.2MIM-A01

The MIM-A01 presents five LEDs, which indicate the devices current operating mode. After the power supply has been switched on, a self test will be executed. The end of this test is indicated by a acoustic signal (short beep).

						SUPER MODEM
								56k
				DC 10...30V		Service Mail in	Mail out Modem Mode
				-	+	Power	Line	COM1 (RS232)
DC 10...30V			Service	Mail in		Mail out		Modem Mode
	-	+	Power		Line			COM1 (RS232)
Fig. 5-1:	LEDs on MIM-A01

Power	Mail in	Line	Mail out	Modem Mode
(yellow)	(red)	(green)	(yellow)	(red)

Starting self test

Testing LEDs

Testing memory

Flashes

Modem is fully operational

Duration: approx. 12 sec

Tab. 5-1:LEDs during the self-test

5 - 1 MITSUBISHI ELECTRIC