Mitsubishi Electronics WD-52627 Connecting a Wall Outlet Cable or Cable Box, Standard Cable Box

Connecting a Wall Outlet Cable or Cable Box

Wall Outlet Cable

(can be used with a CableCARD™)

Figure 1

It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for CableCARD™ use and to download TV Guide On Screen® listings.

1.Connect the primary incoming coaxial lead cable to ANT 1/MAIN on the TV back panel.

2.For an optional secondary antenna source, connect an antenna (or cable) to ANT 2/AUX.

3.If you have subscribed to a CableCARD™ service, the CableCARD can now be inserted into the CableCARD SLOT. Using a Phillips screwdriver, remove the CableCARD cover screws. Insert the CableCARD, then replace the cover and screws. The top of the card should face in the direction the CARD TOP arrow indicates.

Additional CableCARD information is on page 20. Detailed TV Guide On Screen information is in the separate User’s Manual.

		57 CBDL QBOFM
5P "/5 ."*/	5P "/5 "69	TFDUJPO
	 $BCMF$"3%5. 4-05
	DPWFS SFNPWFE
 1SJNBSZ 8BMM	 0QUJPOBM 4FDPOEBSZ
	"OUFOOB PS $BCMF
0VUMFU $BCMF

Figure 1. Wall Outlet Cable

Standard Cable Box

(analog cable box, other than an HDTV cable box, compatible with PIP)

Figure 2

3 coaxial cables and one two-way RF splitter are required. These are not included with the TV.

Note: See page 29 to connect an HDTV cable box.

1.Connect the incoming cable to IN on an RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

3.Connect one coaxial cable from OUT on the RF splitter to IN on the analog cable box.

4.Connect one coaxial cable from OUT on the cable box to ANT-2 AUX on the TV back panel.

5.After the cable box is connected to ANT-2 AUX as shown, open NetCommand and go to the RF Connection for Cable screen and do the following:

a.Check the RF check box.

b.For antenna, select ANT-2.

c.For Channel, select the channel to which the TV must be tuned for your cable box. The default channel is 3.

When this setup is complete, you can use the TV remote control to change channels on the cable box.

		DTV/CABLE/
57 CBDL		VHF/UHF
QBOFM		ANT 1 / MAIN	ANT 2 / AUX
TFDUJPO
	5P "/5 ."*/			5P "/5 "69
	*55&3	065
*ODPNJOH	*/ 41 8": 580-	065
$BCMF
3' 4QMJUUFS				*/	065
		$BCMF #PY CBDL
		QBOFM TFDUJPO

IMPORTANT

Additional connection cables are not provided with the TV. They are available at most electronics stores.

Figure 2. Connecting a Cable Box

Note: To use a cable box connected to ANT‑2 as shown above, you must make the noted NetCommand changes. The changes are required to change

the NetCommand cable-box default connection (Component-1) to the actual connection (ANT-2).

24 Chapter 2. Connecting