NetCommand® Initial Setup, continued
Review Screen
Figure 6
After you have made your device choices, the Review Screen will display. It is important to review the settings to ensure that they are correct. If necessary, you can use <Back to return to the Device Setup screen to make changes.
Finish Screen
Figure 7
To complete the NetCommand setup, select Finish from the Finish screen.
If you wish to change any of the pre- configured inputs or names for the devices, or add devices not in the
If your A/V receiver was not listed, select Edit to add the AVR and then assign all devices to new AVR inputs.
Figure 6. Review screen
Note: The Review screen lists the TV input and A/V receiver input used with each device. You must correctly identify the inputs you used when you connected the devices. If you have not connected your devices, write down these inputs as a guide. If you cannot use these inputs, or if you would like to change the name of a device, use the instructions in Edit NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all selections made are finalized.
On the Review screen, adding or deleting check marks will turn the adjacent devices or inputs On or Off. 1394 device names only appear on the Review screen when the devices are connected to the TV.
Figure 7. Finish screen
It may still be necessary to memorize the available channels for
44 | Chapter 3. NetCommand Setup and Editing |
