Mitsubishi Electronics WD-62530 manual Lamp Indicator, Status Indicator, Reset, Yellow, Red

16Chapter 1. Television Overview

LAMP Indicator

LED Color	TV Condition	Additional Information
None	Normal TV on or standby condition.	Normal operation.
Green	TV just powered off and lamp is	Starts to blink 30 seconds after turning off TV. TV can be turned
	cooling.	on before blinking starts or after blinking stops, but not while the
		indicator is blinking. Normal operation.
Yellow	1. Lamp access door is open or	TV will not operate until lamp access door is secure. See Appendix D
	not secure.	for installation information.
	2. No lamp installed.	TV will not operate without a lamp. See Appendix C for installation
		information.
Red	Lamp no longer illuminates and has	Replace the lamp cartridge. The TV will not operate when the
	reached the end of the lamp life.	lamp no longer illuminates. See Appendix C for installation infor-
		mation.

STATUS Indicator

LED Color	TV Condition	Additional Information
None	Normal TV on or standby condition.	Normal operation.
Yellow	Room temperature is too high.	TV will not operate when the ambient room temperature is too
		high. Turn off the TV and wait until the room temperature drops.
Red	TV may require service.	Turn off the TV and unplug the set from the AC power source.
		Wait one minute and then plug the set back in.
		If the LED is still on, contact your dealer or a Mitsubishi Authorized
		Service Center. See www.mitsubishi-tv.com or call 1-800-332-2119
		to receive Authorized Service Center information.

System Reset Button

	If the TV does not respond to the
	remote control, front panel controls,
������	or will not power on/off, press the
�������	SYSTEM RESET button on the front panel
	with a pointed object, such as the
	point of a pencil or end tip of a paper-
	clip. The green LED will flash quickly
	for about one minute.

When the green LED stops flashing, you may turn on the TV. The changes you made most recently, before using SYSTEM RESET, may be lost. Changes you made previously, however, are not lost.

A/V Reset

If you wish to reset the A/V (Audio/Video) settings back to the factory defaults:

•To reset all settings at once, press GUIDE and FORMAT on the front panel at the same time.

•To reset the defaults for individual devices, use the A/V Memory Reset selection on the Audio/Video menu.

Side Panel Inputs

The side panel (Input 3) provides an easily accessible set of standard audio/video jacks that allow you to connect a camcorder or other audio/video device.

Note that if you connect to the S-VIDEOjack, the VIDEO jack is deactivated; the VIDEO jack is active only when there is no S-Video connection.