Mitsubishi Electronics WD-62530 manual Wall Outlet Cable no cable box, Antenna with a Single Lead

Chapter 2. TV Connections 23

Wall Outlet Cable (no cable box)

It is very important to connect the incoming cable for your primary viewing source to ANT 1/MAIN.

1.Connect the primary incoming coaxial lead cable to ANT 1/MAIN on the TV back panel.

2.For an optional secondary antenna source, connect an antenna (or cable) to ANT 2/AUX.

�������������

Antennas with Separate UHF and VHF Leads

Required: UHF/VHF combiner

This is not included with the TV, but is available at most electronics stores.

1.Connect the UHF and VHF antenna leads to the UHF/ VHF combiner.

2.Push the combiner onto ANT 1/MAIN on the TV back panel.

�������

���

��� �������������������	������������
����������������
		�������
	�������
	����	�������
��� �������������	�������������	�������
������������
	����������������

Mitsubishi strongly recommends you avoid using antennas with flat twin leads. Flat twin lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

Figure 5. Wall Outlet Cable

Antenna with a Single Lead

For antennas with flat twin leads

Required: 300-ohm-to-75-ohm transformer.

This is not included with the TV, but is available at most electronics stores.

1.For an antenna with flat twin leads, connect the 300- ohm twin leads to the 300-ohm-to-75-ohm trans- former.

2.Push the 75-ohm side of the transformer onto ANT 1/MAIN on the TV back panel.

For cable or antenna with coaxial lead

Connect the coaxial lead directly to ANT 1/MAIN on the TV back panel.

�������������
������������ �������������
��������������� ����������������
�������
���
���������������	�
�������
����	�
��������
�������
��������

�����������

�������

�������� ��

���

���

�������������

�������� ���������

���������� �����������

���� �����

������������

����������

�����������

����������

�������������

�������������

�������

���

��

�������

����

��	����	����
	����	����

Figure 7. Connecting separate UHF and VHF Antennas

Figure 6. Connecting a Single Antenna