Mitsubishi Electronics WD-62530 manual Older Cable Box, Camcorder

28Chapter 2. TV Connections

Older Cable Box

Required: 3 coaxial cables, one two-way RF splitter. These are not included with the TV.

When this setup is complete, you can use the TV remote control, when programmed, to change channels on the cable box.

Note: This connection is not recommended. The other connections described in this chapter provide bet- ter quality audio and video to the TV.

1.Connect the incoming cable to IN on the RF splitter.

2.Connect one coaxial cable from OUT on the RF split- ter to ANT 1/MAIN on the TV back panel.

3.Connect one coaxial cable from OUT on the RF split- ter to IN on the standard cable box.

4.Connect one coaxial cable from OUT on the cable box to ANT 2/AUX on the TV back panel.

�������������
��
�������		�������������
���							���
				�����������������		�����	������
				�����������������		��������	�����
				���������������������������		����������	�������
							���
	�������						������
							�����
							�������
�������							������
����	�������
							������
	������������	� ���������� � ����� ���	��	��	��	� ���������� � ����� ���	� ���������� � ����� ���
��						���������������������������������
						�����������
		�������������				������	������
	������������	������

Camcorder

Required: Analog stereo audio cables and either an S- Video or composite video cable.

1.Connect either an S-Video or composite video cable from VIDEO OUT on the camcorder to VIDEO or S-VIDEOon the TV Side Panel (Input 3). Connect only one type of video cable; S-Video is recommended, if available.

2.Connect left (white) and right (red) audio cables from AUDIO OUT on the camcorder to AUDIO L and AUDIO R on the TV Side Panel (Input 3).

�������������

��

���������������������

��

	���������		��
			��� ���	�� ����������������
���	��
	�����	��	��
			�����������

�	�������
��
	�����
��

� �����

�

Figure 14. Connecting an older cable box

��

	��
���������	��
�����

��

Figure 15. Analog connections for a camcorder