1.2.6.4. Assembling base stands and cubes
1.Assemble base stands.
2.Adjust level adjusters to make the base stand both level and plumb by means of a spirit level.
Base stands
Level adjusters
3.Place a cube on the base stand. Caution
Do not grip the
4.Fix the cube at 4 points with supplied hexagon socket head bolts, spring washers and flat
Hexagon socket head bolt
Spring washer
washers. | Flat washer | |
| Caution |
|
| When holding up a cube, be careful not |
|
| to put your hand between the cube and |
|
| the base stand. |
|
5.Place the next bottom row cube on the base stand and fix it in the same way.
6.Join right and left cubes at 4 points with supplied hexagon socket head bolts, spring washers and flat washers.
7.Place cubes for the upper row on the assembled units.
8.Fix them vertically and horizontally at 4 points each with
supplied hexagon socket head bolts, spring washers and flat washers.
9. Stop up the holes on both sides with supplied joint hole | Joint hole seals |
|
seals, which holes are not used for a display wall.
Caution
To avoid units from falling, measure horizontal and vertical degrees with a level etc. to make sure the units are stably assembled.
10.Run cables through the internal cabinets according to the chapter 1.3.3 on page 24 before attaching the screen unit.
PH50, XL50, XL21 series
18