1.4.1.2. Operation mode
This product has two operation modes: “normal mode” and “advanced mode”. Use the normal mode in usual operation. Switch to the advanced mode when you set up or adjust the product. Two modes can be switched by [NORMAL] button when there is no adjustment menu on screen.
1.4.1.2.1.Normal mode
The normal mode allows you to turn off the power by [POWER] button, to display status information by [DISPLAY] button, to change the operation mode by [NORMAL] button and to call a display memory by number buttons.
Adjustment menus cannot be called in the normal mode.
1.4.1.2.2.Advanced mode
In advanced mode, status information appears on screen as |
|
| |
! ANALOG NO SIGNAL | ID01 | ||
described in right figure. | |||
|
| ||
1. Status display: | Status Input port Comment | Set ID |
•“!” mark appears when values in a menu are changed. It is also displayed when a value is automatically changed by internal process.
•In Changer, “☀” mark appears when the status of a spare lamp is other than “NEW”.
•During lamp position auto calibration (for Changer) and initial sensor value obtaining, the operating status is noticed with figures such as “3”, “4” or “7”. When the function has worked correctly, it disappears after
2.Input port: Displaying current input port.
3.Comment:
•“NO SIGNAL” is displayed when any image signal is not input.
•“TEST *” is displayed during internal test patterns displaying.
•“MUTE” is displayed during picture mute.
4.Set ID: Displaying a set ID.
PH50, XL50, XL21 series
26