Mitsubishi Electronics XL50, XL21 installation manual For Changer

2.1.2.2.For Changer

With HOT EXCHANGE menu (chapter 1.5.1.18, on page 43), you can set the allowance the replacement while main lamp lighting.

In the FORBID setting, the product automatically shuts down when you open the lamp cover.

In the ALLOW setting, take care not to burn your hands when you replace a spare lamp during main lamp operation.

To prevent burn or injury, it is recommended to turn off the main power switch and unplug the power cord from the wall outlet before the replacement.

1.Rear: Loosen screw(s) in the upper door to open.

In 67”PH50, turn the center screw in the lower door 90 degrees anti-clockwise to unlock with Allen wrench (4mm) to open the door. (Go to step 4).

Front: Open the screen unit (chapter 1.2.7.1, on page 21). (Go to step 4)

Upper door

Screw(s)

Center screw ( 67”PH50)

Lower door

2.Rear: Lift up the latch in the partition door. (No need in 67”PH50.)

Latch

Partition door

3.Rear: Open the partition door. (No need in 67”PH50.)

PH50, XL50, XL21 series Set-up and Installation Manual

74