Mitsubishi Electronics XL50, XL21 installation manual Adjustment

3.For horizontal adjustment:

50”: Loosen two screws in the right screen guide to adjust its

horizontal position and fix them. 67”: Loosen the screw in the bottom screen guide to adjust its horizontal position and fix it. The screen guide has punch marks at the adjustable range (+/- 2mm) and its center.

4.For vertical adjustment: Loosen two screws each in the left and right screen guides to adjust

their vertical positions and fix them. same position as described above.

67”: The screen guides have the punch marks at the

5.Close the screen units (chapter 1.2.7.2, on page 22).

6.Check the screen gaps and repeat the steps until you get reasonable gaps.

For vertical adjustment

For vertical adjustment

For horizontal adjustment

50” Left screen guide

For horizontal

adjustment

67” Bottom screen guide

1.2.6.6. Fixing to the wall and floor

50” Right screen guide

For vertical adjustment

67” Screen guide (both side)

1.Attach floor-fixing brackets on 4 level adjusters below the base stand and fix them to the floor with anchor bolts.

2.Fix the upper back part of the display wall to the back wall with wall-fixing brackets as shown

in the following figure.

Hexagon socket head cap screws (M6)

Wall-fixing brackets

Anchor bolts

Adjusters Anchor bolts

Floor-fixing brackets

Caution

Make sure the whole set is assembled firmly and installed stably. To prevent the set from falling due to unpredictable events such as earthquakes and shocks, fix the set firmly to the wall and floor. Furthermore, carefully confirm the strength of the fixing area of the installation place (wall and floor). The wall and floor fixing method differs according to the number of the assembled units.

PH50, XL50, XL21 series Set-up and Installation Manual

20