Mitsubishi Electronics XL21, XL50 installation manual As needed, you can adjust the screen gaps

11.Press down the slide lock levers in both sides to unlock, and draw the screen-holding arms till locked.

67”: The levers can be unlocked respectively.

Screen-holding arm

Slide lock lever (Inside the arm)

12.Reinstall the screen unit in its original cabinet. Put the pins inside the screen unit on the retainers at the top of the screen-holding arms, following which make the screen upright. Make sure it will be locked securely.

67”: Screen attaching/detaching work should be done by two or more people.

Pin

Retainer

screen-holding arm

13.Press down the slide lock levers in both sides to unlock, and push the screen unit along the rail till the end.

67”: The levers can be unlocked respectively.

50”: You don’t have to tighten the removed two screen-fixing

bolts.	Slide lock lever (Inside the arm)
1.2.6.5. Screen gap adjustment
This adjustment is normally unnecessary.		2mm
As needed, you can adjust the screen gaps.
		(3mm)

1. Estimate a distance to move the screens so that the screen gaps will approximately be:

2 mm for 50” or

3 mm for 67”.

2.Open the screen units (chapter 1.2.7.1, on page 21).

2mm

(3mm)

REV 2.4

19