product features

Designer Series Gas Fireplaces

product SPECIFICATIONS

This appliance has been certified for use with either natural or propane gas. See appropriate data plates.

This appliance is not for use with solid fuels.

The appliance is approved for bedroom or bedsit- ting room installations.

The appliance must be installed in accordance with local codes if any. If none exist use the cur- rent installation code. ANSI Z223.1/NFPA 54 in the USA, CSA B149 in Canada.

This appliance is mobile home approved.

This appliance is approved for bathroom instal- lation.

The appliance must be properly connected to a venting system.

The appliance is not approved for closet or recessed installations.

The efficiency rating of this appliance is a product thermal efficiency rating determined under con- tinuous operating conditions and was determined independently of any installed system.

HIGH ELEVATIONS

Input ratings are shown in BTU per hour and are certi- fied without deration for elevations up to 4,500 feet (1,370 m) above sea level.

For elevations above 4,500 feet (1,370 m) in USA, installation must be in accordance with the current ANSI Z223.1/NFPA 54 and/or local codes having jurisdiction.

In Canada, please consult provincial and/or local authorities having jurisdiction for installation at eleva- tions above 4,500 feet (1,370 m).

GAS pressures

 

Natural

Propane (LP)

Inlet Minimum

4.5” w.c.

11.0” w.c.

Inlet Maximum

10.5” w.c.

13.0” w.c.

Manifold Pressure

3.5” w.c.

10.0” w.c.

 

 

 

Optional

 

Remote

 

Receiver

 

Hi/Lo Knob

FP2276

 

Off/Pilot/On

 

Knob

 

Control Panel

Blower Control

Figure 1 -

Designer Series Fireplace Controls

Before You START

Read this homeowner manual thoroughly and follow all instructions carefully. Inspect all contents for shipping damage and immediately inform your dealer if any damage is found. Do not install any unit with damaged, incomplete, or substitute parts. Check your packing list to verify that all listed parts have been received. You should have the following:

Fireplace (Firebox and Burner System)

Log Set

Lava Rock

Rock Wool

Deflector Shield (to be used with Simpson DuraVent Horizontal Termination – P/N 985)

Items Required For Installation

Phillips Screwdriver

Framing Materials

Hammer

Wall Finishing Materials

Saw and/or saber saw

Level

Measuring Tape

Electric Drill and Bits

Tee Joint

Pliers

Square

Pipe Wrench

Caulking Material (Noncombustible)

Fireplace Surround Material (Noncombustible)

Piping Complying with Local Codes

Pipe Sealant Approved for use with Propane/LPG (Resistant to Sulfur Compounds)

Gas Specifications & ORIFICE SIZE

 

 

Max.

Min.

 

 

 

Input

Input

Orifice

Model

Fuel

Btu/h

Btu/h

Size

624DVNVC

Nat.

36,000

25,000

#44

624DVPVC

LP

36,000

26,000

#54

624DVNEC

Nat.

36,000

25,000

#44

624DVPEC

LP

36,000

26,000

#54

42D0200

Page 5
Image 5
Monessen Hearth CR, PF, CL)NVC/PVC, 624DV(ST manual Product features, High Elevations