LOG PLACEMENT | Designer Series Gas Fireplaces |
Before you begin — This unit is supplied with eight ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Excessive sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones or vermiculite to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.
Install logs and rock wool (ember material) in firebox
1.Remove glass frame. Refer to Glass Frame Removal, Page 31.
2.Carefully remove logs from wrapping.
3.Place left log (#1) on left end of grate. Line up two (2) pin holes in bottom of log with two (2) pins on grate. Log #1 will always be to the left of the control panel. Figure 41
4.Place right log (#2) on right end of grate. Line up three (3) pin holes in bottom of log with three
(3) pins on grate. Figure 42
Grate
Left Log (#1)
LG638
Control Panel
Pins
Figure 41 -
Install Left Log (#1)
Figure 42 -
Install Right Log (#2)
Right Log (#2)
Pins
Control Panel
42D0200 | 31 |
