Motorola 9500 manual You may see one of these messages

If you want to...	Then...
End Current Call	Press Cat any time.
	Press Muntil you will see End
	Held Call, and then press Oto
End Call that is on	select.
Hold	The held call is disconnected, the
	current call remains connected,
	and you see End Call?.

You may see one of these messages:

Message	Description
Trying	Your phone is attempting to switch
	between the current and held call.
Hold	The attempt to hold a call was
Failed	unsuccessful.
Cannot Hold	A call is already on hold. You can
Second Call	only place one call on hold.
Reconnect	The held call could not be made
Failed	active again.
	Your phone is working on a
Busy	previous command. Wait a short
Try Later	time before repeating the new
	command.

To place a call on hold, you must send a phone flash (see page 62 for more information) along with the appropriate feature code provided by your service provider. To return to your initial call, you must send another phone flash. To send a phone flash, see page 62.

This feature is not available in GSM cellular mode.

Cellular

Mode (CDMA/ AMPS)

Cellular

Mode (GSM)

Using In-Call Features 61