Motorola DR 3000 service manual Transceiver Board Removal

Disassembly/Reassembly Procedures: Transmit and Receive Radio Disassembly — Detailed 5-13

5.Remove the transceiver board by sliding a finger into the opening provided at the front of the radio and gently press up on the 30-pin connector, lifting up the front of the board, as shown in Figure 5-10. Then, slide the transceiver board towards the front of the radio to allow the RF/DC connectors to clear the chassis. Handle the transceiver board by the edges only and store it in an antistatic bag.

NOTE: If the RF/DC connector gaskets remain in the chassis, remove them and place them back on the connectors.

!The thermal pads can act as an adhesive and cause stress to critical components on the transceiver board if the transceiver board is lifted too

C a u t i o n quickly.

Figure 5-10. Transceiver Board Removal

6866576D03-A February 21, 2007