Motorola I580 service manual Registration/Call Test, See the Strong Signal Environment section

FIELD LEVEL TEST MODES AND PROCEDURES: Registration/Call Test

8.4Registration/Call Test

Use this test on a unit having any of the following symptoms: No Service failures, Please Wait...

Registering failures. (Use a reference unit to get a baseline.)

Note: For 900 MHz verification, please perform the BER Test. May require ordering additional option for test. Contact Motorola Customer Service (see Appendix A).

Set up the R-2660 for iDEN

Mobile operation, and connect the unit to the RF IN/OUT connector.

See Figure 7-1 on page 7-3.

Notes:

1.See the Strong Signal Environment section.

2.Master reset can be completed on the unit by pressing Menu, Settings, Security.

3.Registration and calls might take over 1 minute to complete.

4.Make sure the R-2660 is set to a frequency in the radio bandmap.

Power up
the unit. Enter initial		Verify the
Registration mode (see	Fail		OK
		R-2660 calibration, setup,
Operating the R-2660). Press Start.		and cable continuity.
The Call SEQ: 1 thru 6 lights up
		Fix, if necessary.
when the unit has
registered.
Pass
Verify the
unit can complete		Verify the
an interconnect call. Press
		unit is programmed
End/Home until unit displays			Fail
	Fail	for Half Rate if attempting
Ready. Press Interconnect (3:1 or 6:1)
		a 3:1 phone call or Full Rate if
and Start on the R-2660. Press Send
		attempting a 6:1 phone
on the unit. The Call SEQ: 1 thru 8
		call. Repeat the
lights up when the unit has
		test.	Pass
entered Phone
mode.			Perform
			BER Test.

Pass		Pass	Fail
	Unit passed test. Look for
			Replace the
	system, coverage, accessory,
	or software problems.		Main board.

68P80401P05 63