Installation 2 - 3

Installing the VC5090 in a Forklift
Follow the instructions below to properly install the VC5090 in a forklift.
• Determine the best location for mounting the vehicle computer taking into consideration the driver’s field of
view and ease of accessing the vehicle computer.
• Install the appropriate mounting hardware.The VC5090 ships with four cap screws (3/8” - 16 - 2”) for securing
the mounting bracket. If the supplied cap screws are not long enough, use 3/8” - 16 - X stainless steel cap
screws where X represents the length in inches of the required cap screws.
• Connect the vehicle computer to the vehicle’s wiring system.

Positioning the Vehicle Computer

• Determine the best position for the vehicle computer and all the associated components. If a similar vehicle
computer was previously installed, check to see if the position it used is suitable for the VC5090.
• Test the installation for at least 30 minutes before installing on another vehicle. Record all details:
• Check that the position of the vehicle computer does not obstruct vehicle controls.
Figure 2-2
View Obstruction
• Check that the vehicle computer does not obstruct the driver's view.
• Check the position of the vehicle computer for user comfort over long periods.
• Check positioning to avoid extreme wrist angles that may cause injury.
CAUTION A competent engineer must perform the installation in a vehicle. Improper installation can injure the
operator and damage your vehicle and/or the VC5090.