Installation 2 - 41
8. When using a normally open switch, select both the Enable Terminal Locking and For DeadManPedal check
boxes.
Figure 2-60
Terminal Lock Tab
9. In the Select control for terminal locking drop-down list, select the COM port that the In-Motion Detector cable is
connected to (either COM1 or COM2).
10. In the Complete Lockup Timeout drop-down list, select the amount of time that the VC5090 waits before it
unlocks once the switch is deactivated (pedal is disengaged). During this time period, the touch screen,
backlight and keyboard are disabled.
11. In the Screen Blank Timeout drop-down list, select the amount of time after the Complete Lockup TImeout that
the touch screen is active. The touch screen is enabled but the backlight and keyboard are disabled.
12. Tap OK.
To change the Terminal Lock password:
1. On the vehicle computer, tap > Settings > Control Panel > VC5090 System Management icon. The System
Management window displays.
2. Tap the Termina l Lock tab. The Terminal Lock Password window appears.
Figure 2-61
System Management - Terminal Lock
3. Enter the assigned password and tap OK. The password is case sensitive.The default password is “vc5090”.
4. Tap Set New PASSWORD. The Set New Password window appears.
OEM Version 04.22.0001
and lower OEM Version 05.26.0000
and higher