ASSEMBLY INSTRUCTIONS

Motor Housing

Nut

Blower/Vacuum

Tube

Screw

Self-Tapping Screw

Fig. 1

Removing

WARNING: To prevent serious personal injury, stop the engine and allow the impeller to stop before attaching or removing tubes.

1.Remove the 2 (two) self-tapping screws from either side of the housing.

2.Remove the 2 (two) screws and nuts holding the blower/vacuum tube on the housing (Fig. 1).

NOTE: Keep the hardware in a safe place for future use.

3.Remove the blower/vacuum tube from the motor housing.

4.Replace the blower/vacuum tube before use.

Screw

Self Tapping

and Nut

Screw

Screw and Nut

Fig. 2

ATTACHING AND REMOVING THE VACUUM BAG

Attaching

1.Attach the vacuum bag to the vacuum bag hook on the blower/vacuum tube (Fig. 3).

Vacuum Bag Hook

Fig. 3

2.Slide the vacuum bag tube over the debris exhaust tube on the housing. Push the tube until the latching tabs on both sides click into place, securing the bag on the unit (Fig. 4).

Removing

1.Press the latching tabs on both sides of the vacuum bag tube and pull the vacuum bag from the unit (Fig. 5).

2.Detach the vacuum bag from the vacuum bag hook.

Latching Tabs

Debris Exhaust Tube

Vacuum Bag Tube

Vacuum Bag

Zipper

Fig. 4

Latching Tabs

Fig. 5

GB6