Windows NT

The following step-by-step procedure will install the TCP/IP Direct Connect and configure it for use without MPC+. Installation and configuration of TCP/IP Direct Connect using MPC+ is discussed in the “ MPC+ for Windows NT Installation Guide”.

The PBSA driver must be installed before TCP/IP Direct Connect (see Page 10).

Step

1.From the Windows NT Control Panel invoke Network configuration (Figure 5-11).

Figure 5-11. Invoking Network Configuration

2.Click on the Adapters tab (Figure 5-12). Make sure the adapter is listed. If not, you must install the adapter before installing TCP/IP Direct Connect (Refer to Page 8).

TCP/IP Direct Connect 29

Page 35
Image 35
Multi-Tech Systems 40-01459-D0-001 manual Invoking Network Configuration