Multi-Tech Systems MT2834MR6 manual CDn

Appendix

&CDn	n = 0 or 1	Cleardown at Disconnect
	***	&CD0	Enable cleardown.
		&CD1	Disable cleardown.
Ds	s = phone #	Dial
		Dial telephone number s, where s may include up to 60 digits or T, P, R, comma,
		colon, and semicolon characters.
DsNd	s = phone #	Store Phone Number
	d = 0 or 1	To store, enter D followed by telephone number s, then N followed by directory
		number d.
&Dn	n = 0, 1, 2,	Data Terminal Ready Control
	or 3	&D0	Modem ignores DTR signal.
		&D1	When DTR drops, the modem hangs up. While DTR is low, the modem accepts
			commands but will not dial or auto-answer until DTR goes high again.
	***	&D2	Same as &D1.
		&D3	When DTR drops, the modem hangs up and resets as if an ATZ or an AT&F
			command was issued.
%DCn	n = 0 or 1	Command Mode Control
	***	%DC0 Enable command mode.
		%DC1 Disable command mode.
%DFn	n = 0 or 1	Line Probe Data Format
	***	%DF0	V.34 line probe data displayed in graph format.
		%DF1	V.34 line probe data displayed in table format.
%DPn	n = 0 or 1	Line Probe Data Read
	***	%DP0 Disable reading of line probe data during the V.34 handshake.
		%DP1 Enable reading of line probe data during the V.34 handshake.
>DTn	n = 0 or 1	DTMF Detection
	***	>DT0	Disable DTMF detection.
		>DT1	Enable DTMF detection when off-hook.
En	n = 0 or 1	Echo Command Mode Characters
		E0	Do not echo command mode characters.
	***	E1	Do echo command mode characters.

99