Multi-Tech Systems MT2834MR6 manual 104

Appendix

&Tn	n = 4 or 5	Respond to Remote Digital Loopback Signal
		&T4	Enable response to remote digital loopback signal.
	***	&T5	Disable response to remote digital loopback signal.
$Tn	n = 0 or 1	Calling Tone
		$T0	Enable calling tone.
	***	$T1	Disable calling tone.
#Tn	n = 0 or 1	Trellis-Coded Modulation
		#T0	Disable trellis-coded modulation.
	***	#T1	Enable trellis-coded modulation.
Un	n = 0–3	Loopback Test Modes
		U0	Enable analog loop originate mode.
		U1	Enable analog loop answer mode.
		U2	Enable remote digital loopback mode.
		U3	Enable local digital loopback mode.
Vn	n = 0 or 1	Result Codes (Verbose/Terse)
		V0	Result codes sent as digits (terse response).
	***	V1	Result codes sent as words (verbose response).
#Vn	n = 0 or 1	V.32terbo Handshake
	***	#V0	Enable V.32terbo tones in answer mode.
		#V1	Disable V.32terbo tones in answer mode.
W	In dialing	Wait for New Dial Tone
	command	Causes modem to wait for new dial tone. (X2 or X4 must be selected.)
&Wn	n = 0 or 1	Store	Configuration
		&W0	Store current settings in NVRAM; modem will load these at power-on or with the
			ATZ command instead of reading factory ROM defaults.
	***	&W1	Do not store settings.
Xn	n = 0–4	Result Codes and Call Progress Selection
	***	X0	Basic result codes (CONNECT only); does not look for dial tone or busy.
		X1	Extended result codes (w/ CONNECT 1200, CONNECT 2400, etc.); does not
			look for dial tone or busy signal.
		X2	Extended result codes with NO DIAL TONE; does not look for busy signal.
		X3	Extended result codes with BUSY; does not look for dial tone.
		X4	Extended result codes with NO DIAL TONE and BUSY.
#Xn	n = 0 or 1	Number of XOFF Characters Sent
	***	#X0	Single XOFF character sent after buffer is full.
		#X1	Multiple XOFF characters sent (one for every character received after buffer is
			full).
Yn	n = 0 or 1	Long Space Disconnect
	***	Y0	Disable sending or responding to long space break signal on disconnect.
		Y1	Enable sending or responding to long space break signal on disconnect. (Both
			modems must have Y1 set.)
Z	n/a	Modem Reset
		Reset modem to default values. Defaults come from NVRAM if &W0 is set, from ROM
		if &W1 is set.
,	In dial	Dialing Pause
	command	Comma; causes dialing pause for time set by S8.

104