Multi-Tech Systems MT2834ZPX owner manual Configuration/Installation Procedure

MT2834ZPX Owner's Manual

Configuration/Installation Procedure

Perform the procedures in Table 2-1 to configure and install the MT2834ZPX card into your ISA or EISA bus host computer.

Table 2-1. Configuration and Installation Procedure

StepProcedure

1Make sure your computer and any peripheral equipment connected to it, are turned off. Failure to do so may damage both your modem and your PC. The card may be installed in any 286-, 386- , 486- or Pentium based computer with an ISA or EISA bus architecture.

2Remove the cover of your computer as instructed in your computer’s documentation.

3Locate the unused slot(s) which you will be using for your modem card, and remove the slot cover(s) per the instructions in your computer’s documentation.

4Figure 2-1 illustrates the default COM port and IRQ value setting for this card (COM2/IRQ3). If your application requires an alternate setting, remove the berg jumpers from the COM2/IRQ3 position and place them in a position that supports your application. The MT2834ZPX can be configured for either a COM1, COM2, COM3 or COM4 communication port; with a selection of five IRQ values for each port. By this means, the user may select an identical COM port because of the expanded IRQ value selection option (e.g., the MT2834ZPX has a factory default of COM2/IRQ3...a Mouse device can also be configured at COM2 but at IRQ4...a Printer device configured at COM2 but at IRQ7...).

10