Multi-Tech Systems MT2834ZPX owner manual =0 thru

MT2834ZPX Owner's Manual

COMMAND:	&En (Cont'd)
	&E3 selects no modem-initiated flow control.
	&E4 selects CTS modem-initiated flow control.
	&E5 selects Xon/Xoff modem-initiated flow control.
	&E6 selects Xon/Xoff not passed through.
	&E7 selects Xon/Xoff passed through.
	&E8 selects Enq/Ack pacing off.
	&E9 selects Enq/Ack pacing on.
	&E10 selects Normal Mode flow control off.
	&E11 selects Normal Mode flow control on.
	&E12 selects Pacing off.
	&E13 means Pacing on.
	&E14 means data compression disabled.
	&E15 means data compression enabled.
COMMAND:	%En
VALUES:	n=0 thru 5
DEFAULT:	%E1
DESCRIPTION:
	%E0 = Modem Won’t Escape.
	%E1 = +++ Method (default setting).
	%E2 = Break Method.
	%E3 = Either +++ or Break Method.
	%E4 = No "OK" Response to +++
	%E5 = "OK" Response to +++
COMMAND:	#Fn
VALUES:	n = 0 thru 2
DEFAULT:	#F2
DESCRIPTION:
	#F0 means no fallback when on-line.
	#F1 means fallback from 33600 to 4800 bps
	when on-line (increments of 2400 bps).
	#F2 means fallback to 4800 bps from 33.6K
	bps/fall forward if line improves (increments
	of 2400 bps).
COMMAND:	&Fn
VALUES:	n = 0, 8 or 9
DEFAULT:	&F8
DESCRIPTION:
	&F loads factory default values from ROM.
	&F8 reads factory default values when &F is issued.
	&F9 reads parameters stored in nonvolatile
	memory when &F is issued.

28